blob: 789763cf427aceacc9ff584a42389c56e24e34a2 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
|
# SPDX-License-Identifier: GPL-2.0
%YAML 1.2
---
$id: http://devicetree.org/schemas/serial/rs485.yaml#
$schema: http://devicetree.org/meta-schemas/core.yaml#
title: RS485 serial communications
description: The RTS signal is capable of automatically controlling line
direction for the built-in half-duplex mode. The properties described
hereafter shall be given to a half-duplex capable UART node.
maintainers:
- Rob Herring <robh@kernel.org>
properties:
rs485-rts-delay:
description: prop-encoded-array <a b>
$ref: /schemas/types.yaml#/definitions/uint32-array
items:
items:
- description: Delay between rts signal and beginning of data sent in
milliseconds. It corresponds to the delay before sending data.
default: 0
maximum: 100
- description: Delay between end of data sent and rts signal in milliseconds.
It corresponds to the delay after sending data and actual release
of the line.
default: 0
maximum: 100
rs485-rts-active-low:
description: drive RTS low when sending (default is high).
$ref: /schemas/types.yaml#/definitions/flag
rs485-rx-active-high:
description: Polarity of receiver enable signal (when separate from RTS).
True indicates active high (default is low).
$ref: /schemas/types.yaml#/definitions/flag
linux,rs485-enabled-at-boot-time:
description: enables the rs485 feature at boot time. It can be disabled
later with proper ioctl.
$ref: /schemas/types.yaml#/definitions/flag
rs485-rx-during-tx:
description: enables the receiving of data even while sending data.
$ref: /schemas/types.yaml#/definitions/flag
rs485-term-gpios:
description: GPIO pin to enable RS485 bus termination.
maxItems: 1
additionalProperties: true
...
|
