diff options
Diffstat (limited to 'drivers/net/bnx2x_main.c')
-rw-r--r-- | drivers/net/bnx2x_main.c | 112 |
1 files changed, 75 insertions, 37 deletions
diff --git a/drivers/net/bnx2x_main.c b/drivers/net/bnx2x_main.c index 177cb467ba90..ae8b7b517ea8 100644 --- a/drivers/net/bnx2x_main.c +++ b/drivers/net/bnx2x_main.c @@ -2598,6 +2598,22 @@ static void bnx2x_attn_int_asserted(struct bnx2x *bp, u32 asserted) } } +static inline void bnx2x_fan_failure(struct bnx2x *bp) +{ + int port = BP_PORT(bp); + + /* mark the failure */ + bp->link_params.ext_phy_config &= ~PORT_HW_CFG_XGXS_EXT_PHY_TYPE_MASK; + bp->link_params.ext_phy_config |= PORT_HW_CFG_XGXS_EXT_PHY_TYPE_FAILURE; + SHMEM_WR(bp, dev_info.port_hw_config[port].external_phy_config, + bp->link_params.ext_phy_config); + + /* log the failure */ + printk(KERN_ERR PFX "Fan Failure on Network Controller %s has caused" + " the driver to shutdown the card to prevent permanent" + " damage. Please contact Dell Support for assistance\n", + bp->dev->name); +} static inline void bnx2x_attn_int_deasserted0(struct bnx2x *bp, u32 attn) { int port = BP_PORT(bp); @@ -2615,36 +2631,21 @@ static inline void bnx2x_attn_int_deasserted0(struct bnx2x *bp, u32 attn) BNX2X_ERR("SPIO5 hw attention\n"); + /* Fan failure attention */ switch (XGXS_EXT_PHY_TYPE(bp->link_params.ext_phy_config)) { case PORT_HW_CFG_XGXS_EXT_PHY_TYPE_SFX7101: - /* Fan failure attention */ - - /* The PHY reset is controlled by GPIO 1 */ - bnx2x_set_gpio(bp, MISC_REGISTERS_GPIO_1, - MISC_REGISTERS_GPIO_OUTPUT_LOW, port); /* Low power mode is controlled by GPIO 2 */ bnx2x_set_gpio(bp, MISC_REGISTERS_GPIO_2, MISC_REGISTERS_GPIO_OUTPUT_LOW, port); - /* mark the failure */ - bp->link_params.ext_phy_config &= - ~PORT_HW_CFG_XGXS_EXT_PHY_TYPE_MASK; - bp->link_params.ext_phy_config |= - PORT_HW_CFG_XGXS_EXT_PHY_TYPE_FAILURE; - SHMEM_WR(bp, - dev_info.port_hw_config[port]. - external_phy_config, - bp->link_params.ext_phy_config); - /* log the failure */ - printk(KERN_ERR PFX "Fan Failure on Network" - " Controller %s has caused the driver to" - " shutdown the card to prevent permanent" - " damage. Please contact Dell Support for" - " assistance\n", bp->dev->name); + /* The PHY reset is controlled by GPIO 1 */ + bnx2x_set_gpio(bp, MISC_REGISTERS_GPIO_1, + MISC_REGISTERS_GPIO_OUTPUT_LOW, port); break; default: break; } + bnx2x_fan_failure(bp); } if (attn & (AEU_INPUTS_ATTN_BITS_GPIO3_FUNCTION_0 | @@ -5509,6 +5510,58 @@ static void bnx2x_reset_common(struct bnx2x *bp) REG_WR(bp, GRCBASE_MISC + MISC_REGISTERS_RESET_REG_2_CLEAR, 0x1403); } + +static void bnx2x_setup_fan_failure_detection(struct bnx2x *bp) +{ + u32 val; + u8 port; + u8 is_required = 0; + + val = SHMEM_RD(bp, dev_info.shared_hw_config.config2) & + SHARED_HW_CFG_FAN_FAILURE_MASK; + + if (val == SHARED_HW_CFG_FAN_FAILURE_ENABLED) + is_required = 1; + + /* + * The fan failure mechanism is usually related to the PHY type since + * the power consumption of the board is affected by the PHY. Currently, + * fan is required for most designs with SFX7101, BCM8727 and BCM8481. + */ + else if (val == SHARED_HW_CFG_FAN_FAILURE_PHY_TYPE) + for (port = PORT_0; port < PORT_MAX; port++) { + u32 phy_type = + SHMEM_RD(bp, dev_info.port_hw_config[port]. + external_phy_config) & + PORT_HW_CFG_XGXS_EXT_PHY_TYPE_MASK; + is_required |= + ((phy_type == + PORT_HW_CFG_XGXS_EXT_PHY_TYPE_SFX7101) || + (phy_type == + PORT_HW_CFG_XGXS_EXT_PHY_TYPE_BCM8481)); + } + + DP(NETIF_MSG_HW, "fan detection setting: %d\n", is_required); + + if (is_required == 0) + return; + + /* Fan failure is indicated by SPIO 5 */ + bnx2x_set_spio(bp, MISC_REGISTERS_SPIO_5, + MISC_REGISTERS_SPIO_INPUT_HI_Z); + + /* set to active low mode */ + val = REG_RD(bp, MISC_REG_SPIO_INT); + val |= ((1 << MISC_REGISTERS_SPIO_5) << + MISC_REGISTERS_SPIO_INT_OLD_SET_POS); + REG_WR(bp, MISC_REG_SPIO_INT, val); + + /* enable interrupt to signal the IGU */ + val = REG_RD(bp, MISC_REG_SPIO_EVENT_EN); + val |= (1 << MISC_REGISTERS_SPIO_5); + REG_WR(bp, MISC_REG_SPIO_EVENT_EN, val); +} + static int bnx2x_init_common(struct bnx2x *bp) { u32 val, i; @@ -5738,27 +5791,12 @@ static int bnx2x_init_common(struct bnx2x *bp) bp->port.need_hw_lock = 1; break; - case PORT_HW_CFG_XGXS_EXT_PHY_TYPE_SFX7101: - /* Fan failure is indicated by SPIO 5 */ - bnx2x_set_spio(bp, MISC_REGISTERS_SPIO_5, - MISC_REGISTERS_SPIO_INPUT_HI_Z); - - /* set to active low mode */ - val = REG_RD(bp, MISC_REG_SPIO_INT); - val |= ((1 << MISC_REGISTERS_SPIO_5) << - MISC_REGISTERS_SPIO_INT_OLD_SET_POS); - REG_WR(bp, MISC_REG_SPIO_INT, val); - - /* enable interrupt to signal the IGU */ - val = REG_RD(bp, MISC_REG_SPIO_EVENT_EN); - val |= (1 << MISC_REGISTERS_SPIO_5); - REG_WR(bp, MISC_REG_SPIO_EVENT_EN, val); - break; - default: break; } + bnx2x_setup_fan_failure_detection(bp); + /* clear PXP2 attentions */ REG_RD(bp, PXP2_REG_PXP2_INT_STS_CLR_0); |