Merge tag 'armsoc-drivers' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc

Pull ARM SoC driver updates from Arnd Bergmann:
 "Driver updates for ARM SoCs, including a couple of newly added
  drivers:

   - The Qualcomm external bus interface 2 (EBI2), used in some of their
     mobile phone chips for connecting flash memory, LCD displays or
     other peripherals

   - Secure monitor firmware for Amlogic SoCs, and an NVMEM driver for
     the EFUSE based on that firmware interface.

   - Perf support for the AppliedMicro X-Gene performance monitor unit

   - Reset driver for STMicroelectronics STM32

   - Reset driver for SocioNext UniPhier SoCs

  Aside from these, there are minor updates to SoC-specific bus,
  clocksource, firmware, pinctrl, reset, rtc and pmic drivers"

* tag 'armsoc-drivers' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc: (50 commits)
  bus: qcom-ebi2: depend on HAS_IOMEM
  pinctrl: mvebu: orion5x: Generalise mv88f5181l support for 88f5181
  clk: mvebu: Add clk support for the orion5x SoC mv88f5181
  dt-bindings: EXYNOS: Add Exynos5433 PMU compatible
  clocksource: exynos_mct: Add the support for ARM64
  perf: xgene: Add APM X-Gene SoC Performance Monitoring Unit driver
  Documentation: Add documentation for APM X-Gene SoC PMU DTS binding
  MAINTAINERS: Add entry for APM X-Gene SoC PMU driver
  bus: qcom: add EBI2 driver
  bus: qcom: add EBI2 device tree bindings
  rtc: rtc-pm8xxx: Add support for pm8018 rtc
  nvmem: amlogic: Add Amlogic Meson EFUSE driver
  firmware: Amlogic: Add secure monitor driver
  soc: qcom: smd: Reset rx tail rather than tx
  memory: atmel-sdramc: fix a possible NULL dereference
  reset: hi6220: allow to compile test driver on other architectures
  reset: zynq: add driver Kconfig option
  reset: sunxi: add driver Kconfig option
  reset: stm32: add driver Kconfig option
  reset: socfpga: add driver Kconfig option
  ...

1 files changed, 24 insertions, 5 deletions

diff --git a/drivers/media/rc/meson-ir.c b/drivers/media/rc/meson-ir.c
index fcc3b82d1454..003fff07ade2 100644
--- a/drivers/media/rc/meson-ir.c
+++ b/drivers/media/rc/meson-ir.c
@@ -24,6 +24,7 @@
 
 #define DRIVER_NAME		"meson-ir"
 
+/* valid on all Meson platforms */
 #define IR_DEC_LDR_ACTIVE	0x00
 #define IR_DEC_LDR_IDLE		0x04
 #define IR_DEC_LDR_REPEAT	0x08
@@ -32,12 +33,21 @@
 #define IR_DEC_FRAME		0x14
 #define IR_DEC_STATUS		0x18
 #define IR_DEC_REG1		0x1c
+/* only available on Meson 8b and newer */
+#define IR_DEC_REG2		0x20
 
 #define REG0_RATE_MASK		(BIT(11) - 1)
 
-#define REG1_MODE_MASK		(BIT(7) | BIT(8))
-#define REG1_MODE_NEC		(0 << 7)
-#define REG1_MODE_GENERAL	(2 << 7)
+#define DECODE_MODE_NEC		0x0
+#define DECODE_MODE_RAW		0x2
+
+/* Meson 6b uses REG1 to configure the mode */
+#define REG1_MODE_MASK		GENMASK(8, 7)
+#define REG1_MODE_SHIFT		7
+
+/* Meson 8b / GXBB use REG2 to configure the mode */
+#define REG2_MODE_MASK		GENMASK(3, 0)
+#define REG2_MODE_SHIFT		0
 
 #define REG1_TIME_IV_SHIFT	16
 #define REG1_TIME_IV_MASK	((BIT(13) - 1) << REG1_TIME_IV_SHIFT)
@@ -158,8 +168,15 @@ static int meson_ir_probe(struct platform_device *pdev)
 	/* Reset the decoder */
 	meson_ir_set_mask(ir, IR_DEC_REG1, REG1_RESET, REG1_RESET);
 	meson_ir_set_mask(ir, IR_DEC_REG1, REG1_RESET, 0);
-	/* Set general operation mode */
-	meson_ir_set_mask(ir, IR_DEC_REG1, REG1_MODE_MASK, REG1_MODE_GENERAL);
+
+	/* Set general operation mode (= raw/software decoding) */
+	if (of_device_is_compatible(node, "amlogic,meson6-ir"))
+		meson_ir_set_mask(ir, IR_DEC_REG1, REG1_MODE_MASK,
+				  DECODE_MODE_RAW << REG1_MODE_SHIFT);
+	else
+		meson_ir_set_mask(ir, IR_DEC_REG2, REG2_MODE_MASK,
+				  DECODE_MODE_RAW << REG2_MODE_SHIFT);
+
 	/* Set rate */
 	meson_ir_set_mask(ir, IR_DEC_REG0, REG0_RATE_MASK, MESON_TRATE - 1);
 	/* IRQ on rising and falling edges */
@@ -197,6 +214,8 @@ static int meson_ir_remove(struct platform_device *pdev)
 
 static const struct of_device_id meson_ir_match[] = {
 	{ .compatible = "amlogic,meson6-ir" },
+	{ .compatible = "amlogic,meson8b-ir" },
+	{ .compatible = "amlogic,meson-gxbb-ir" },
 	{ },
 };