1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
|
/* SPDX-License-Identifier: GPL-2.0 */
/*
* Asm versions of Xen pv-ops, suitable for direct use.
*
* We only bother with direct forms (ie, vcpu in pda) of the
* operations here; the indirect forms are better handled in C.
*/
#include <asm/thread_info.h>
#include <asm/processor-flags.h>
#include <asm/segment.h>
#include <asm/asm.h>
#include <xen/interface/xen.h>
#include <linux/linkage.h>
/* Pseudo-flag used for virtual NMI, which we don't implement yet */
#define XEN_EFLAGS_NMI 0x80000000
/*
* This is run where a normal iret would be run, with the same stack setup:
* 8: eflags
* 4: cs
* esp-> 0: eip
*
* This attempts to make sure that any pending events are dealt with
* on return to usermode, but there is a small window in which an
* event can happen just before entering usermode. If the nested
* interrupt ends up setting one of the TIF_WORK_MASK pending work
* flags, they will not be tested again before returning to
* usermode. This means that a process can end up with pending work,
* which will be unprocessed until the process enters and leaves the
* kernel again, which could be an unbounded amount of time. This
* means that a pending signal or reschedule event could be
* indefinitely delayed.
*
* The fix is to notice a nested interrupt in the critical window, and
* if one occurs, then fold the nested interrupt into the current
* interrupt stack frame, and re-process it iteratively rather than
* recursively. This means that it will exit via the normal path, and
* all pending work will be dealt with appropriately.
*
* Because the nested interrupt handler needs to deal with the current
* stack state in whatever form its in, we keep things simple by only
* using a single register which is pushed/popped on the stack.
*/
.macro POP_FS
1:
popw %fs
.pushsection .fixup, "ax"
2: movw $0, (%esp)
jmp 1b
.popsection
_ASM_EXTABLE(1b,2b)
.endm
SYM_CODE_START(xen_iret)
/* test eflags for special cases */
testl $(X86_EFLAGS_VM | XEN_EFLAGS_NMI), 8(%esp)
jnz hyper_iret
push %eax
ESP_OFFSET=4 # bytes pushed onto stack
/* Store vcpu_info pointer for easy access */
#ifdef CONFIG_SMP
pushw %fs
movl $(__KERNEL_PERCPU), %eax
movl %eax, %fs
movl %fs:xen_vcpu, %eax
POP_FS
#else
movl %ss:xen_vcpu, %eax
#endif
/* check IF state we're restoring */
testb $X86_EFLAGS_IF>>8, 8+1+ESP_OFFSET(%esp)
/*
* Maybe enable events. Once this happens we could get a
* recursive event, so the critical region starts immediately
* afterwards. However, if that happens we don't end up
* resuming the code, so we don't have to be worried about
* being preempted to another CPU.
*/
setz %ss:XEN_vcpu_info_mask(%eax)
xen_iret_start_crit:
/* check for unmasked and pending */
cmpw $0x0001, %ss:XEN_vcpu_info_pending(%eax)
/*
* If there's something pending, mask events again so we can
* jump back into xen_hypervisor_callback. Otherwise do not
* touch XEN_vcpu_info_mask.
*/
jne 1f
movb $1, %ss:XEN_vcpu_info_mask(%eax)
1: popl %eax
/*
* From this point on the registers are restored and the stack
* updated, so we don't need to worry about it if we're
* preempted
*/
iret_restore_end:
/*
* Jump to hypervisor_callback after fixing up the stack.
* Events are masked, so jumping out of the critical region is
* OK.
*/
je xen_hypervisor_callback
1: iret
xen_iret_end_crit:
_ASM_EXTABLE(1b, asm_iret_error)
hyper_iret:
/* put this out of line since its very rarely used */
jmp hypercall_page + __HYPERVISOR_iret * 32
SYM_CODE_END(xen_iret)
.globl xen_iret_start_crit, xen_iret_end_crit
/*
* This is called by xen_hypervisor_callback in entry_32.S when it sees
* that the EIP at the time of interrupt was between
* xen_iret_start_crit and xen_iret_end_crit.
*
* The stack format at this point is:
* ----------------
* ss : (ss/esp may be present if we came from usermode)
* esp :
* eflags } outer exception info
* cs }
* eip }
* ----------------
* eax : outer eax if it hasn't been restored
* ----------------
* eflags }
* cs } nested exception info
* eip }
* return address : (into xen_hypervisor_callback)
*
* In order to deliver the nested exception properly, we need to discard the
* nested exception frame such that when we handle the exception, we do it
* in the context of the outer exception rather than starting a new one.
*
* The only caveat is that if the outer eax hasn't been restored yet (i.e.
* it's still on stack), we need to restore its value here.
*/
SYM_CODE_START(xen_iret_crit_fixup)
/*
* Paranoia: Make sure we're really coming from kernel space.
* One could imagine a case where userspace jumps into the
* critical range address, but just before the CPU delivers a
* PF, it decides to deliver an interrupt instead. Unlikely?
* Definitely. Easy to avoid? Yes.
*/
testb $2, 2*4(%esp) /* nested CS */
jnz 2f
/*
* If eip is before iret_restore_end then stack
* hasn't been restored yet.
*/
cmpl $iret_restore_end, 1*4(%esp)
jae 1f
movl 4*4(%esp), %eax /* load outer EAX */
ret $4*4 /* discard nested EIP, CS, and EFLAGS as
* well as the just restored EAX */
1:
ret $3*4 /* discard nested EIP, CS, and EFLAGS */
2:
ret
SYM_CODE_END(xen_iret_crit_fixup)
|
