From 8c670714223d58086695d007b76b3e3ead54e4f5 Mon Sep 17 00:00:00 2001 From: "Timofei V. Bondarenko" Date: Wed, 20 Dec 2006 19:20:07 +0100 Subject: [ALSA] _snd_cmipci_uswitch_put doesn't set zero flags Playing with spdif output on cmipci i've noticed the SPDO5V option does not change appropriate bits the register. The _snd_cmipci_uswitch_put checks the change in flags in wrong way. If 'active' state of an option corresponds to a _zero_ bits in a hw register then function fails. The SPDO5V is the sample. In the most cases 'active' state of option is set through an non-zerio bits in a register. This case works fine. The fix attached. Unfortunately i was unable to change spdif output voltage anyway. Although the register changes right at least. From: Timofei V. Bondarenko Signed-off-by: Takashi Iwai Signed-off-by: Jaroslav Kysela --- sound/pci/cmipci.c | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-) (limited to 'sound') diff --git a/sound/pci/cmipci.c b/sound/pci/cmipci.c index 71c58df4af28..70face7e1048 100644 --- a/sound/pci/cmipci.c +++ b/sound/pci/cmipci.c @@ -2198,7 +2198,8 @@ static int _snd_cmipci_uswitch_put(struct snd_kcontrol *kcontrol, val = inb(cm->iobase + args->reg); else val = snd_cmipci_read(cm, args->reg); - change = (val & args->mask) != (ucontrol->value.integer.value[0] ? args->mask : 0); + change = (val & args->mask) != (ucontrol->value.integer.value[0] ? + args->mask_on : (args->mask & ~args->mask_on)); if (change) { val &= ~args->mask; if (ucontrol->value.integer.value[0]) -- cgit v1.2.3-58-ga151