From 88ecf814c47f577248751ddbe9626d98aeef5783 Mon Sep 17 00:00:00 2001 From: David Woodhouse Date: Thu, 29 May 2008 11:01:51 +0300 Subject: firmware: Add firmware installation to modules_install, add firmware_install For 'make modules_install', install any firmware required by the modules which are being installed. Also add a 'make firmware_install' target which doesn't depend on the configuration, but installs _all_ available in-kernel-tree firmware into $(INSTALL_FW_PATH), which defaults to /lib/firmware. This is intended for distributors to make arch-independent (and config-independent) packages containing firmware. Signed-off-by: David Woodhouse --- firmware/Makefile | 24 +++++++++++++++++------- 1 file changed, 17 insertions(+), 7 deletions(-) (limited to 'firmware') diff --git a/firmware/Makefile b/firmware/Makefile index cc25f5600d5d..3742feeb066f 100644 --- a/firmware/Makefile +++ b/firmware/Makefile @@ -9,13 +9,22 @@ fwabs := $(addprefix $(srctree)/,$(filter-out /%,$(fwdir)))$(filter /%,$(fwdir)) fw-external-y := $(subst ",,$(CONFIG_EXTRA_FIRMWARE)) -# If CONFIG_FIRMWARE_IN_KERNEL is not set, then don't include any firmware -ifneq ($(CONFIG_FIRMWARE_IN_KERNEL),y) -fw-shipped-y := -endif +# There are three cases to care about: +# 1. Building kernel with CONFIG_FIRMWARE_IN_KERNEL=y -- $(fw-shipped-y) should +# include the firmware files to include, according to .config +# 2. 'make modules_install', which will install firmware for modules, and +# _also_ for the in-kernel drivers when CONFIG_FIRMWARE_IN_KERNEL=n +# 3. 'make firmware_install', which installs all firmware, unconditionally. -firmware-y := $(fw-external-y) $(fw-shipped-y) -firmware-dirs := $(sort $(patsubst %,$(objtree)/$(obj)/%/,$(dir $(firmware-y) $(fw-shipped-)))) +# For the former two cases we want $(fw-shipped-y) and $(fw-shipped-m) to be +# accurate. In the latter case it doesn't matter -- it'll use $(fw-shipped-all). +# But be aware that the config file might not be included at all. + + +fw-shipped-all := $(fw-shipped-y) $(fw-shipped-m) $(fw-shipped-) + +# Directories which we _might_ need to create, so we have a rule for them. +firmware-dirs := $(sort $(patsubst %,$(objtree)/$(obj)/%/,$(dir $(fw-external-y) $(fw-shipped-all)))) quiet_cmd_mkdir = MKDIR $(patsubst $(objtree)/%,%,$@) cmd_mkdir = mkdir -p $@ @@ -81,7 +90,8 @@ $(obj)/%: $(obj)/%.ihex | $(objtree)/$(obj)/$$(dir %) $(firmware-dirs): $(call cmd,mkdir) -obj-y := $(patsubst %,%.gen.o, $(firmware-y)) +obj-y += $(patsubst %,%.gen.o, $(fw-external-y)) +obj-$(CONFIG_FIRMWARE_IN_KERNEL) += $(patsubst %,%.gen.o, $(fw-shipped-y)) # Remove .S files and binaries created from ihex # (during 'make clean' .config isn't included so they're all in $(fw-shipped-)) -- cgit v1.2.3-58-ga151