From 8ec93459655a3618dedec6360bb28d63f0010ef6 Mon Sep 17 00:00:00 2001 From: Jens Osterkamp Date: Thu, 4 May 2006 05:59:41 -0400 Subject: spidernet: enable support for bcm5461 ethernet phy A newer board revision changed the type of ethernet phy. Moreover, this generalizes the way that a phy gets switched into fiber mode when autodetection is not available. Signed-off-by: Jens Osterkamp Signed-off-by: Arnd Bergmann Signed-off-by: Stephen Hemminger --- drivers/net/spider_net.c | 10 +--------- 1 file changed, 1 insertion(+), 9 deletions(-) (limited to 'drivers/net/spider_net.c') diff --git a/drivers/net/spider_net.c b/drivers/net/spider_net.c index b36838bfb8dc..394339d5e87c 100644 --- a/drivers/net/spider_net.c +++ b/drivers/net/spider_net.c @@ -1794,15 +1794,7 @@ spider_net_setup_phy(struct spider_net_card *card) if (phy->def->ops->setup_forced) phy->def->ops->setup_forced(phy, SPEED_1000, DUPLEX_FULL); - /* the following two writes could be moved to sungem_phy.c */ - /* enable fiber mode */ - spider_net_write_phy(card->netdev, 1, MII_NCONFIG, 0x9020); - /* LEDs active in both modes, autosense prio = fiber */ - spider_net_write_phy(card->netdev, 1, MII_NCONFIG, 0x945f); - - /* switch off fibre autoneg */ - spider_net_write_phy(card->netdev, 1, MII_NCONFIG, 0xfc01); - spider_net_write_phy(card->netdev, 1, 0x0b, 0x0004); + phy->def->ops->enable_fiber(phy); phy->def->ops->read_link(phy); pr_info("Found %s with %i Mbps, %s-duplex.\n", phy->def->name, -- cgit v1.2.3-58-ga151