From 44e74840d668d23b65e22772828e2600641b6ab0 Mon Sep 17 00:00:00 2001 From: Jarkko Nikula Date: Thu, 24 Sep 2009 16:23:17 -0700 Subject: omap: Fix MMC gpio_wp for BeagleBoard C2 and above Earlier BeagleBoards were using pad AH8 muxed to GPIO29 for MMC write-protect. However, this signal has been changed to pad AG9 in board revision C2. Fix this by adding mux configuration for pad AG9, runtime check for board revisions and set the gpio number and pad muxing accordingly. Signed-off-by: Jarkko Nikula Signed-off-by: Tony Lindgren --- arch/arm/mach-omap2/board-omap3beagle.c | 7 ++++++- arch/arm/mach-omap2/mux.c | 2 ++ 2 files changed, 8 insertions(+), 1 deletion(-) (limited to 'arch/arm/mach-omap2') diff --git a/arch/arm/mach-omap2/board-omap3beagle.c b/arch/arm/mach-omap2/board-omap3beagle.c index 500c9956876d..70df6b4dbcd4 100644 --- a/arch/arm/mach-omap2/board-omap3beagle.c +++ b/arch/arm/mach-omap2/board-omap3beagle.c @@ -139,8 +139,13 @@ static struct gpio_led gpio_leds[]; static int beagle_twl_gpio_setup(struct device *dev, unsigned gpio, unsigned ngpio) { + if (system_rev >= 0x20 && system_rev <= 0x34301000) { + omap_cfg_reg(AG9_34XX_GPIO23); + mmc[0].gpio_wp = 23; + } else { + omap_cfg_reg(AH8_34XX_GPIO29); + } /* gpio + 0 is "mmc0_cd" (input/IRQ) */ - omap_cfg_reg(AH8_34XX_GPIO29); mmc[0].gpio_cd = gpio + 0; twl4030_mmc_init(mmc); diff --git a/arch/arm/mach-omap2/mux.c b/arch/arm/mach-omap2/mux.c index 339ba80ee683..b5fac32aae70 100644 --- a/arch/arm/mach-omap2/mux.c +++ b/arch/arm/mach-omap2/mux.c @@ -460,6 +460,8 @@ MUX_CFG_34XX("AF26_34XX_GPIO0", 0x1e0, OMAP34XX_MUX_MODE4 | OMAP34XX_PIN_INPUT) MUX_CFG_34XX("AF22_34XX_GPIO9", 0xa18, OMAP34XX_MUX_MODE4 | OMAP34XX_PIN_INPUT) +MUX_CFG_34XX("AG9_34XX_GPIO23", 0x5ee, + OMAP34XX_MUX_MODE4 | OMAP34XX_PIN_INPUT) MUX_CFG_34XX("AH8_34XX_GPIO29", 0x5fa, OMAP34XX_MUX_MODE4 | OMAP34XX_PIN_INPUT) MUX_CFG_34XX("U8_34XX_GPIO54_OUT", 0x0b4, -- cgit v1.2.3-58-ga151