From b2c03941b50944a268ee4d5823872f220809a3ba Mon Sep 17 00:00:00 2001 From: Corey Minyard Date: Wed, 6 Dec 2006 20:41:00 -0800 Subject: [PATCH] IPMI: Allow hot system interface remove This modifies the IPMI driver so that a lower-level interface can be dynamically removed while in use so it can support hot-removal of hardware. It also adds the ability to specify and dynamically change the IPMI interface the watchdog timer and the poweroff code use. Signed-off-by: Corey Minyard Signed-off-by: Andrew Morton Signed-off-by: Linus Torvalds --- Documentation/IPMI.txt | 9 ++++++++- 1 file changed, 8 insertions(+), 1 deletion(-) (limited to 'Documentation') diff --git a/Documentation/IPMI.txt b/Documentation/IPMI.txt index 0e3924ecd76b..9101cbf2d883 100644 --- a/Documentation/IPMI.txt +++ b/Documentation/IPMI.txt @@ -502,7 +502,10 @@ used to control it: modprobe ipmi_watchdog timeout= pretimeout= action= preaction= preop= start_now=x - nowayout=x + nowayout=x ifnum_to_use=n + +ifnum_to_use specifies which interface the watchdog timer should use. +The default is -1, which means to pick the first one registered. The timeout is the number of seconds to the action, and the pretimeout is the amount of seconds before the reset that the pre-timeout panic will @@ -624,5 +627,9 @@ command line. The parameter is also available via the proc filesystem in /proc/sys/dev/ipmi/poweroff_powercycle. Note that if the system does not support power cycling, it will always do the power off. +The "ifnum_to_use" parameter specifies which interface the poweroff +code should use. The default is -1, which means to pick the first one +registered. + Note that if you have ACPI enabled, the system will prefer using ACPI to power off. -- cgit v1.2.3-58-ga151