From 732d481127abaa0add41ee918191ea08e9ede17e Mon Sep 17 00:00:00 2001 From: Wolfram Sang Date: Fri, 18 Sep 2009 22:45:48 +0200 Subject: i2c/chips: Remove deprecated pca9539 driver The pca9539 driver in drivers/i2c/chips which just exports its registers to sysfs is superseded by drivers/gpio/pca953x.c which properly uses the gpiolib. As this driver has been deprecated for more than a year, finally remove it. Signed-off-by: Wolfram Sang Acked-by: Ben Gardner Signed-off-by: Jean Delvare --- Documentation/i2c/chips/pca9539 | 58 ----------------------------------------- 1 file changed, 58 deletions(-) delete mode 100644 Documentation/i2c/chips/pca9539 (limited to 'Documentation/i2c') diff --git a/Documentation/i2c/chips/pca9539 b/Documentation/i2c/chips/pca9539 deleted file mode 100644 index 6aff890088b1..000000000000 --- a/Documentation/i2c/chips/pca9539 +++ /dev/null @@ -1,58 +0,0 @@ -Kernel driver pca9539 -===================== - -NOTE: this driver is deprecated and will be dropped soon, use -drivers/gpio/pca9539.c instead. - -Supported chips: - * Philips PCA9539 - Prefix: 'pca9539' - Addresses scanned: none - Datasheet: - http://www.semiconductors.philips.com/acrobat/datasheets/PCA9539_2.pdf - -Author: Ben Gardner - - -Description ------------ - -The Philips PCA9539 is a 16 bit low power I/O device. -All 16 lines can be individually configured as an input or output. -The input sense can also be inverted. -The 16 lines are split between two bytes. - - -Detection ---------- - -The PCA9539 is difficult to detect and not commonly found in PC machines, -so you have to pass the I2C bus and address of the installed PCA9539 -devices explicitly to the driver at load time via the force=... parameter. - - -Sysfs entries -------------- - -Each is a byte that maps to the 8 I/O bits. -A '0' suffix is for bits 0-7, while '1' is for bits 8-15. - -input[01] - read the current value -output[01] - sets the output value -direction[01] - direction of each bit: 1=input, 0=output -invert[01] - toggle the input bit sense - -input reads the actual state of the line and is always available. -The direction defaults to input for all channels. - - -General Remarks ---------------- - -Note that each output, direction, and invert entry controls 8 lines. -You should use the read, modify, write sequence. -For example. to set output bit 0 of 1. - val=$(cat output0) - val=$(( $val | 1 )) - echo $val > output0 - -- cgit v1.2.3-58-ga151