From bcebb4cc20c8932f614d273a065190fe3614ca42 Mon Sep 17 00:00:00 2001 From: Libor Pechacek Date: Fri, 4 Dec 2015 10:10:03 +0100 Subject: Fix CFQ I/O scheduler parameter name in documentation As seen in block/cfq-iosched.c, the parameter name is low_latency. Signed-off-by: Libor Pechacek Signed-off-by: Jonathan Corbet --- Documentation/block/cfq-iosched.txt | 15 +++++++-------- 1 file changed, 7 insertions(+), 8 deletions(-) (limited to 'Documentation/block') diff --git a/Documentation/block/cfq-iosched.txt b/Documentation/block/cfq-iosched.txt index f3bc72945cbd..1e4f835a659d 100644 --- a/Documentation/block/cfq-iosched.txt +++ b/Documentation/block/cfq-iosched.txt @@ -81,14 +81,13 @@ on higher end storage. Default value for this parameter is 8ms. -latency -------- -This parameter is used to enable/disable the latency mode of the CFQ -scheduler. If latency mode (called low_latency) is enabled, CFQ tries -to recompute the slice time for each process based on the target_latency set -for the system. This favors fairness over throughput. Disabling low -latency (setting it to 0) ignores target latency, allowing each process in the -system to get a full time slice. +low_latency +----------- +This parameter is used to enable/disable the low latency mode of the CFQ +scheduler. If enabled, CFQ tries to recompute the slice time for each process +based on the target_latency set for the system. This favors fairness over +throughput. Disabling low latency (setting it to 0) ignores target latency, +allowing each process in the system to get a full time slice. By default low latency mode is enabled. -- cgit v1.2.3-58-ga151