summaryrefslogtreecommitdiff
path: root/drivers/net/macb.h
AgeCommit message (Collapse)Author
2007-07-16macb: Use generic PHY layerfrederic RODO
Convert the macb driver to use the generic PHY layer in drivers/net/phy. Signed-off-by: Frederic RODO <f.rodo@til-technologies.fr> Signed-off-by: Haavard Skinnemoen <hskinnemoen@atmel.com> Signed-off-by: Jeff Garzik <jeff@garzik.org>
2007-02-07AT91: MACB supportAndrew Victor
The Atmel MACB Ethernet peripheral is also integrated in the AT91SAM9260 and AT91SAM9263 processors. The differences from the AVR32 version are: * Single peripheral clock. * MII/RMII selection bit is inverted. * Clock enable bit. Original patch from Patrice Vilchez. Signed-off-by: Andrew Victor <andrew@sanpeople.com> Signed-off-by: Haavard Skinnemoen <hskinnemoen@atmel.com> Signed-off-by: Jeff Garzik <jeff@garzik.org>
2006-12-11[PATCH] MACB: Use __raw register accessHaavard Skinnemoen
Since macb is a chip-internal device, use __raw_readl and __raw_writel instead of readl/writel. This will perform native-endian accesses, which is the right thing to do on both AVR32 and ARM devices. Signed-off-by: Haavard Skinnemoen <hskinnemoen@atmel.com> Signed-off-by: Jeff Garzik <jeff@garzik.org>
2006-12-11[PATCH] MACB: Use struct delayed_work instead of struct work_structHaavard Skinnemoen
The macb driver calls schedule_delayed_work() and friends, so we need to use a struct delayed_work along with it. The conversion was explained by David Howells on lkml Dec 5 2006: http://lkml.org/lkml/2006/12/5/269 Signed-off-by: Haavard Skinnemoen <hskinnemoen@atmel.com> Signed-off-by: Jeff Garzik <jeff@garzik.org>
2006-12-02[PATCH] Atmel MACB ethernet driverHaavard Skinnemoen
Driver for the Atmel MACB on-chip ethernet module. Tested on AVR32/AT32AP7000/ATSTK1000. I've heard rumours that it works with AT91SAM9260 as well, and it may be possible to share some code with the at91_ether driver for AT91RM9200. Hardware documentation can be found in the AT32AP7000 data sheet, which can be downloaded from http://www.atmel.com/dyn/products/datasheets.asp?family_id=682 Changes since previous version: * Probe for PHY ID instead of depending on it being provided through platform_data. * Grab initial ethernet address from the MACB registers instead of depending on platform_data. * Set MII/RMII mode correctly. These changes are mostly about making the driver more compatible with the at91 infrastructure. Signed-off-by: Haavard Skinnemoen <hskinnemoen@atmel.com> Signed-off-by: Jeff Garzik <jeff@garzik.org>