diff options
Diffstat (limited to 'drivers/pinctrl')
-rw-r--r-- | drivers/pinctrl/Kconfig | 1 | ||||
-rw-r--r-- | drivers/pinctrl/pinctrl-coh901.c | 77 | ||||
-rw-r--r-- | drivers/pinctrl/pinctrl-coh901.h | 5 | ||||
-rw-r--r-- | drivers/pinctrl/pinctrl-u300.c | 60 |
4 files changed, 135 insertions, 8 deletions
diff --git a/drivers/pinctrl/Kconfig b/drivers/pinctrl/Kconfig index 07f3d8d38580..abfb96408779 100644 --- a/drivers/pinctrl/Kconfig +++ b/drivers/pinctrl/Kconfig @@ -73,6 +73,7 @@ config PINCTRL_U300 bool "U300 pin controller driver" depends on ARCH_U300 select PINMUX + select GENERIC_PINCONF config PINCTRL_COH901 bool "ST-Ericsson U300 COH 901 335/571 GPIO" diff --git a/drivers/pinctrl/pinctrl-coh901.c b/drivers/pinctrl/pinctrl-coh901.c index 724234c9b01b..0797eba3e33a 100644 --- a/drivers/pinctrl/pinctrl-coh901.c +++ b/drivers/pinctrl/pinctrl-coh901.c @@ -23,7 +23,9 @@ #include <linux/list.h> #include <linux/slab.h> #include <linux/pinctrl/consumer.h> +#include <linux/pinctrl/pinconf-generic.h> #include <mach/gpio-u300.h> +#include "pinctrl-coh901.h" /* * Register definitions for COH 901 335 variant @@ -418,8 +420,68 @@ static int u300_gpio_to_irq(struct gpio_chip *chip, unsigned offset) return retirq; } -static int u300_gpio_config(struct gpio_chip *chip, unsigned offset, - enum pin_config_param param, unsigned long data) +/* Returning -EINVAL means "supported but not available" */ +int u300_gpio_config_get(struct gpio_chip *chip, + unsigned offset, + unsigned long *config) +{ + struct u300_gpio *gpio = to_u300_gpio(chip); + enum pin_config_param param = (enum pin_config_param) *config; + bool biasmode; + u32 drmode; + + /* One bit per pin, clamp to bool range */ + biasmode = !!(readl(U300_PIN_REG(offset, per)) & U300_PIN_BIT(offset)); + + /* Mask out the two bits for this pin and shift to bits 0,1 */ + drmode = readl(U300_PIN_REG(offset, pcr)); + drmode &= (U300_GPIO_PXPCR_PIN_MODE_MASK << ((offset & 0x07) << 1)); + drmode >>= ((offset & 0x07) << 1); + + switch(param) { + case PIN_CONFIG_BIAS_HIGH_IMPEDANCE: + *config = 0; + if (biasmode) + return 0; + else + return -EINVAL; + break; + case PIN_CONFIG_BIAS_PULL_UP: + *config = 0; + if (!biasmode) + return 0; + else + return -EINVAL; + break; + case PIN_CONFIG_DRIVE_PUSH_PULL: + *config = 0; + if (drmode == U300_GPIO_PXPCR_PIN_MODE_OUTPUT_PUSH_PULL) + return 0; + else + return -EINVAL; + break; + case PIN_CONFIG_DRIVE_OPEN_DRAIN: + *config = 0; + if (drmode == U300_GPIO_PXPCR_PIN_MODE_OUTPUT_OPEN_DRAIN) + return 0; + else + return -EINVAL; + break; + case PIN_CONFIG_DRIVE_OPEN_SOURCE: + *config = 0; + if (drmode == U300_GPIO_PXPCR_PIN_MODE_OUTPUT_OPEN_SOURCE) + return 0; + else + return -EINVAL; + break; + default: + break; + } + return -ENOTSUPP; +} + +int u300_gpio_config_set(struct gpio_chip *chip, unsigned offset, + enum pin_config_param param) { struct u300_gpio *gpio = to_u300_gpio(chip); unsigned long flags; @@ -620,13 +682,12 @@ static void __init u300_gpio_init_pin(struct u300_gpio *gpio, u300_gpio_direction_output(&gpio->chip, offset, conf->outval); /* Deactivate bias mode for output */ - u300_gpio_config(&gpio->chip, offset, - PIN_CONFIG_BIAS_HIGH_IMPEDANCE, - 0); + u300_gpio_config_set(&gpio->chip, offset, + PIN_CONFIG_BIAS_HIGH_IMPEDANCE); /* Set drive mode for output */ - u300_gpio_config(&gpio->chip, offset, - PIN_CONFIG_DRIVE_PUSH_PULL, 0); + u300_gpio_config_set(&gpio->chip, offset, + PIN_CONFIG_DRIVE_PUSH_PULL); dev_dbg(gpio->dev, "set up pin %d as output, value: %d\n", offset, conf->outval); @@ -637,7 +698,7 @@ static void __init u300_gpio_init_pin(struct u300_gpio *gpio, u300_gpio_set(&gpio->chip, offset, 0); /* Set bias mode for input */ - u300_gpio_config(&gpio->chip, offset, conf->bias_mode, 0); + u300_gpio_config_set(&gpio->chip, offset, conf->bias_mode); dev_dbg(gpio->dev, "set up pin %d as input, bias: %04x\n", offset, conf->bias_mode); diff --git a/drivers/pinctrl/pinctrl-coh901.h b/drivers/pinctrl/pinctrl-coh901.h new file mode 100644 index 000000000000..87294222583e --- /dev/null +++ b/drivers/pinctrl/pinctrl-coh901.h @@ -0,0 +1,5 @@ +int u300_gpio_config_get(struct gpio_chip *chip, + unsigned offset, + unsigned long *config); +int u300_gpio_config_set(struct gpio_chip *chip, unsigned offset, + enum pin_config_param param); diff --git a/drivers/pinctrl/pinctrl-u300.c b/drivers/pinctrl/pinctrl-u300.c index fc4a281caba5..26eb8ccd72d5 100644 --- a/drivers/pinctrl/pinctrl-u300.c +++ b/drivers/pinctrl/pinctrl-u300.c @@ -19,6 +19,9 @@ #include <linux/err.h> #include <linux/pinctrl/pinctrl.h> #include <linux/pinctrl/pinmux.h> +#include <linux/pinctrl/pinconf.h> +#include <linux/pinctrl/pinconf-generic.h> +#include "pinctrl-coh901.h" /* * Register definitions for the U300 Padmux control registers in the @@ -1044,12 +1047,69 @@ static struct pinctrl_gpio_range u300_gpio_ranges[] = { U300_GPIO_RANGE(25, 181, 1), }; +static struct pinctrl_gpio_range *u300_match_gpio_range(unsigned pin) +{ + int i; + + for (i = 0; i < ARRAY_SIZE(u300_gpio_ranges); i++) { + struct pinctrl_gpio_range *range; + + range = &u300_gpio_ranges[i]; + if (pin >= range->pin_base && + pin <= (range->pin_base + range->npins - 1)) + return range; + } + return NULL; +} + +int u300_pin_config_get(struct pinctrl_dev *pctldev, + unsigned pin, + unsigned long *config) +{ + struct pinctrl_gpio_range *range = u300_match_gpio_range(pin); + + /* We get config for those pins we CAN get it for and that's it */ + if (!range) + return -ENOTSUPP; + + return u300_gpio_config_get(range->gc, + (pin - range->pin_base + range->base), + config); +} + +int u300_pin_config_set(struct pinctrl_dev *pctldev, + unsigned pin, + unsigned long config) +{ + struct pinctrl_gpio_range *range = u300_match_gpio_range(pin); + int ret; + + if (!range) + return -EINVAL; + + /* Note: none of these configurations take any argument */ + ret = u300_gpio_config_set(range->gc, + (pin - range->pin_base + range->base), + pinconf_to_config_param(config)); + if (ret) + return ret; + + return 0; +} + +static struct pinconf_ops u300_pconf_ops = { + .is_generic = true, + .pin_config_get = u300_pin_config_get, + .pin_config_set = u300_pin_config_set, +}; + static struct pinctrl_desc u300_pmx_desc = { .name = DRIVER_NAME, .pins = u300_pads, .npins = ARRAY_SIZE(u300_pads), .pctlops = &u300_pctrl_ops, .pmxops = &u300_pmx_ops, + .confops = &u300_pconf_ops, .owner = THIS_MODULE, }; |