diff options
Diffstat (limited to 'drivers/gpu/drm/i915/intel_pm.c')
| -rw-r--r-- | drivers/gpu/drm/i915/intel_pm.c | 18 |
1 files changed, 13 insertions, 5 deletions
diff --git a/drivers/gpu/drm/i915/intel_pm.c b/drivers/gpu/drm/i915/intel_pm.c index 249623d45be0..940bab22d464 100644 --- a/drivers/gpu/drm/i915/intel_pm.c +++ b/drivers/gpu/drm/i915/intel_pm.c @@ -4891,6 +4891,12 @@ static void gen6_set_rps_thresholds(struct drm_i915_private *dev_priv, u8 val) break; } + /* When byt can survive without system hang with dynamic + * sw freq adjustments, this restriction can be lifted. + */ + if (IS_VALLEYVIEW(dev_priv)) + goto skip_hw_write; + I915_WRITE(GEN6_RP_UP_EI, GT_INTERVAL_FROM_US(dev_priv, ei_up)); I915_WRITE(GEN6_RP_UP_THRESHOLD, @@ -4911,6 +4917,7 @@ static void gen6_set_rps_thresholds(struct drm_i915_private *dev_priv, u8 val) GEN6_RP_UP_BUSY_AVG | GEN6_RP_DOWN_IDLE_AVG); +skip_hw_write: dev_priv->rps.power = new_power; dev_priv->rps.up_threshold = threshold_up; dev_priv->rps.down_threshold = threshold_down; @@ -7916,10 +7923,10 @@ static bool skl_pcode_try_request(struct drm_i915_private *dev_priv, u32 mbox, * @timeout_base_ms: timeout for polling with preemption enabled * * Keep resending the @request to @mbox until PCODE acknowledges it, PCODE - * reports an error or an overall timeout of @timeout_base_ms+10 ms expires. + * reports an error or an overall timeout of @timeout_base_ms+50 ms expires. * The request is acknowledged once the PCODE reply dword equals @reply after * applying @reply_mask. Polling is first attempted with preemption enabled - * for @timeout_base_ms and if this times out for another 10 ms with + * for @timeout_base_ms and if this times out for another 50 ms with * preemption disabled. * * Returns 0 on success, %-ETIMEDOUT in case of a timeout, <0 in case of some @@ -7955,14 +7962,15 @@ int skl_pcode_request(struct drm_i915_private *dev_priv, u32 mbox, u32 request, * worst case) _and_ PCODE was busy for some reason even after a * (queued) request and @timeout_base_ms delay. As a workaround retry * the poll with preemption disabled to maximize the number of - * requests. Increase the timeout from @timeout_base_ms to 10ms to + * requests. Increase the timeout from @timeout_base_ms to 50ms to * account for interrupts that could reduce the number of these - * requests. + * requests, and for any quirks of the PCODE firmware that delays + * the request completion. */ DRM_DEBUG_KMS("PCODE timeout, retrying with preemption disabled\n"); WARN_ON_ONCE(timeout_base_ms > 3); preempt_disable(); - ret = wait_for_atomic(COND, 10); + ret = wait_for_atomic(COND, 50); preempt_enable(); out: |