diff options
Diffstat (limited to 'arch/arm/kernel')
| -rw-r--r-- | arch/arm/kernel/hyp-stub.S | 39 |
1 files changed, 8 insertions, 31 deletions
diff --git a/arch/arm/kernel/hyp-stub.S b/arch/arm/kernel/hyp-stub.S index 6607fa817bba..26d8e03b1dd3 100644 --- a/arch/arm/kernel/hyp-stub.S +++ b/arch/arm/kernel/hyp-stub.S @@ -189,19 +189,19 @@ ARM_BE8(orr r7, r7, #(1 << 25)) @ HSCTLR.EE ENDPROC(__hyp_stub_install_secondary) __hyp_stub_do_trap: +#ifdef ZIMAGE teq r0, #HVC_SET_VECTORS bne 1f + /* Only the ZIMAGE stubs can change the HYP vectors */ mcr p15, 4, r1, c12, c0, 0 @ set HVBAR b __hyp_stub_exit +#endif 1: teq r0, #HVC_SOFT_RESTART - bne 1f + bne 2f bx r1 -1: teq r0, #HVC_RESET_VECTORS - beq __hyp_stub_exit - - ldr r0, =HVC_STUB_ERR +2: ldr r0, =HVC_STUB_ERR __ERET __hyp_stub_exit: @@ -210,26 +210,9 @@ __hyp_stub_exit: ENDPROC(__hyp_stub_do_trap) /* - * __hyp_set_vectors: Call this after boot to set the initial hypervisor - * vectors as part of hypervisor installation. On an SMP system, this should - * be called on each CPU. - * - * r0 must be the physical address of the new vector table (which must lie in - * the bottom 4GB of physical address space. - * - * r0 must be 32-byte aligned. - * - * Before calling this, you must check that the stub hypervisor is installed - * everywhere, by waiting for any secondary CPUs to be brought up and then - * checking that BOOT_CPU_MODE_HAVE_HYP(__boot_cpu_mode) is true. - * - * If not, there is a pre-existing hypervisor, some CPUs failed to boot, or - * something else went wrong... in such cases, trying to install a new - * hypervisor is unlikely to work as desired. - * - * When you call into your shiny new hypervisor, sp_hyp will contain junk, - * so you will need to set that to something sensible at the new hypervisor's - * initialisation entry point. + * __hyp_set_vectors is only used when ZIMAGE must bounce between HYP + * and SVC. For the kernel itself, the vectors are set once and for + * all by the stubs. */ ENTRY(__hyp_set_vectors) mov r1, r0 @@ -245,12 +228,6 @@ ENTRY(__hyp_soft_restart) ret lr ENDPROC(__hyp_soft_restart) -ENTRY(__hyp_reset_vectors) - mov r0, #HVC_RESET_VECTORS - __HVC(0) - ret lr -ENDPROC(__hyp_reset_vectors) - #ifndef ZIMAGE .align 2 .L__boot_cpu_mode_offset: |