1 files changed, 0 insertions, 78 deletions
diff --git a/Documentation/virtual/guest-halt-polling.txt b/Documentation/virtual/guest-halt-polling.txt
deleted file mode 100644
index b3a2a294532d..000000000000
--- a/Documentation/virtual/guest-halt-polling.txt
+++ /dev/null
@@ -1,78 +0,0 @@
-Guest halt polling
-==================
-
-The cpuidle_haltpoll driver, with the haltpoll governor, allows
-the guest vcpus to poll for a specified amount of time before
-halting.
-This provides the following benefits to host side polling:
-
-	1) The POLL flag is set while polling is performed, which allows
-	   a remote vCPU to avoid sending an IPI (and the associated
-	   cost of handling the IPI) when performing a wakeup.
-
-	2) The VM-exit cost can be avoided.
-
-The downside of guest side polling is that polling is performed
-even with other runnable tasks in the host.
-
-The basic logic as follows: A global value, guest_halt_poll_ns,
-is configured by the user, indicating the maximum amount of
-time polling is allowed. This value is fixed.
-
-Each vcpu has an adjustable guest_halt_poll_ns
-("per-cpu guest_halt_poll_ns"), which is adjusted by the algorithm
-in response to events (explained below).
-
-Module Parameters
-=================
-
-The haltpoll governor has 5 tunable module parameters:
-
-1) guest_halt_poll_ns:
-Maximum amount of time, in nanoseconds, that polling is
-performed before halting.
-
-Default: 200000
-
-2) guest_halt_poll_shrink:
-Division factor used to shrink per-cpu guest_halt_poll_ns when
-wakeup event occurs after the global guest_halt_poll_ns.
-
-Default: 2
-
-3) guest_halt_poll_grow:
-Multiplication factor used to grow per-cpu guest_halt_poll_ns
-when event occurs after per-cpu guest_halt_poll_ns
-but before global guest_halt_poll_ns.
-
-Default: 2
-
-4) guest_halt_poll_grow_start:
-The per-cpu guest_halt_poll_ns eventually reaches zero
-in case of an idle system. This value sets the initial
-per-cpu guest_halt_poll_ns when growing. This can
-be increased from 10000, to avoid misses during the initial
-growth stage:
-
-10k, 20k, 40k, ... (example assumes guest_halt_poll_grow=2).
-
-Default: 50000
-
-5) guest_halt_poll_allow_shrink:
-
-Bool parameter which allows shrinking. Set to N
-to avoid it (per-cpu guest_halt_poll_ns will remain
-high once achieves global guest_halt_poll_ns value).
-
-Default: Y
-
-The module parameters can be set from the debugfs files in:
-
-	/sys/module/haltpoll/parameters/
-
-Further Notes
-=============
-
-- Care should be taken when setting the guest_halt_poll_ns parameter as a
-large value has the potential to drive the cpu usage to 100% on a machine which
-would be almost entirely idle otherwise.