diff options
| -rw-r--r-- | drivers/gpio/gpio-mmio.c | 2 | ||||
| -rw-r--r-- | drivers/gpio/gpiolib-of.c | 22 |
2 files changed, 20 insertions, 4 deletions
diff --git a/drivers/gpio/gpio-mmio.c b/drivers/gpio/gpio-mmio.c index 71e1af7c2184..d89e78f0ead3 100644 --- a/drivers/gpio/gpio-mmio.c +++ b/drivers/gpio/gpio-mmio.c @@ -619,8 +619,6 @@ int bgpio_init(struct gpio_chip *gc, struct device *dev, ret = gpiochip_get_ngpios(gc, dev); if (ret) gc->ngpio = gc->bgpio_bits; - else - gc->bgpio_bits = roundup_pow_of_two(round_up(gc->ngpio, 8)); ret = bgpio_setup_io(gc, dat, set, clr, flags); if (ret) diff --git a/drivers/gpio/gpiolib-of.c b/drivers/gpio/gpiolib-of.c index d75f6ee37028..89d5e64cf68b 100644 --- a/drivers/gpio/gpiolib-of.c +++ b/drivers/gpio/gpiolib-of.c @@ -203,6 +203,24 @@ static void of_gpio_try_fixup_polarity(const struct device_node *np, */ { "qi,lb60", "rb-gpios", true }, #endif +#if IS_ENABLED(CONFIG_PCI_LANTIQ) + /* + * According to the PCI specification, the RST# pin is an + * active-low signal. However, most of the device trees that + * have been widely used for a long time incorrectly describe + * reset GPIO as active-high, and were also using wrong name + * for the property. + */ + { "lantiq,pci-xway", "gpio-reset", false }, +#endif +#if IS_ENABLED(CONFIG_TOUCHSCREEN_TSC2005) + /* + * DTS for Nokia N900 incorrectly specified "active high" + * polarity for the reset line, while the chip actually + * treats it as "active low". + */ + { "ti,tsc2005", "reset-gpios", false }, +#endif }; unsigned int i; @@ -504,9 +522,9 @@ static struct gpio_desc *of_find_gpio_rename(struct device_node *np, { "reset", "reset-n-io", "marvell,nfc-uart" }, { "reset", "reset-n-io", "mrvl,nfc-uart" }, #endif -#if !IS_ENABLED(CONFIG_PCI_LANTIQ) +#if IS_ENABLED(CONFIG_PCI_LANTIQ) /* MIPS Lantiq PCI */ - { "reset", "gpios-reset", "lantiq,pci-xway" }, + { "reset", "gpio-reset", "lantiq,pci-xway" }, #endif /* |