xfs: debug mode log record crc error injection

XFS now uses CRC verification over a limited section of the log to
detect torn writes prior to a crash. This is difficult to test directly
due to the timing and hardware requirements to cause a short write.

Add a mechanism to inject CRC errors into log records to facilitate
testing torn write detection during log recovery. This mechanism is
dangerous and can result in filesystem corruption. Thus, it is only
available in DEBUG mode for testing/development purposes. Set a non-zero
value to the following sysfs entry to enable error injection:

	/sys/fs/xfs/<dev>/log/log_badcrc_factor

Once enabled, XFS intentionally writes an invalid CRC to a log record at
some random point in the future based on the provided frequency. The
filesystem immediately shuts down once the record has been written to
the physical log to prevent metadata writeback (e.g., AIL insertion)
once the log write completes. This helps reasonably simulate a torn
write to the log as the affected record must be safe to discard. The
next mount after the intentional shutdown requires log recovery and
should detect and recover from the torn write.

Note again that this _will_ result in data loss or worse. For testing
and development purposes only!

Signed-off-by: Brian Foster <bfoster@redhat.com>
Reviewed-by: Dave Chinner <dchinner@redhat.com>
Signed-off-by: Dave Chinner <david@fromorbit.com>

1 files changed, 3 insertions, 0 deletions

diff --git a/fs/xfs/xfs_log_priv.h b/fs/xfs/xfs_log_priv.h
index 8daba7491b13..ed8896310c00 100644
--- a/fs/xfs/xfs_log_priv.h
+++ b/fs/xfs/xfs_log_priv.h
@@ -62,6 +62,7 @@ static inline uint xlog_get_client_id(__be32 i)
 #define XLOG_STATE_CALLBACK  0x0020 /* Callback functions now */
 #define XLOG_STATE_DIRTY     0x0040 /* Dirty IC log, not ready for ACTIVE status*/
 #define XLOG_STATE_IOERROR   0x0080 /* IO error happened in sync'ing log */
+#define XLOG_STATE_IOABORT   0x0100 /* force abort on I/O completion (debug) */
 #define XLOG_STATE_ALL	     0x7FFF /* All possible valid flags */
 #define XLOG_STATE_NOTUSED   0x8000 /* This IC log not being used */
 
@@ -410,6 +411,8 @@ struct xlog {
 	/* The following field are used for debugging; need to hold icloglock */
 #ifdef DEBUG
 	void			*l_iclog_bak[XLOG_MAX_ICLOGS];
+	/* log record crc error injection factor */
+	uint32_t		l_badcrc_factor;
 #endif
 
 };