Linux-2.6.12-rc2v2.6.12-rc2

Initial git repository build. I'm not bothering with the full history,
even though we have it. We can create a separate "historical" git
archive of that later if we want to, and in the meantime it's about
3.2GB when imported into git - space that would just make the early
git days unnecessarily complicated, when we don't have a lot of good
infrastructure for it.

Let it rip!

1 files changed, 55 insertions, 0 deletions

diff --git a/drivers/usb/serial/cypress_m8.h b/drivers/usb/serial/cypress_m8.h
new file mode 100644
index 000000000000..1012ee6b19ce
--- /dev/null
+++ b/drivers/usb/serial/cypress_m8.h
@@ -0,0 +1,55 @@
+#ifndef CYPRESS_M8_H
+#define CYPRESS_M8_H
+
+/* definitions and function prototypes used for the cypress USB to Serial controller */
+
+/* For sending our feature buffer - controlling serial communication states */
+/* Linux HID has no support for serial devices so we do this through the driver */
+#define HID_REQ_GET_REPORT 0x01
+#define HID_REQ_SET_REPORT 0x09
+
+/* List other cypress USB to Serial devices here, and add them to the id_table */
+
+/* DeLorme Earthmate USB - a GPS device */
+#define	VENDOR_ID_DELORME		 0x1163
+#define PRODUCT_ID_EARTHMATEUSB		 0x0100
+
+/* Cypress HID->COM RS232 Adapter */
+#define VENDOR_ID_CYPRESS		 0x04b4
+#define PRODUCT_ID_CYPHIDCOM		 0x5500
+/* End of device listing */
+
+/* Used for setting / requesting serial line settings */
+#define CYPRESS_SET_CONFIG 0x01
+#define CYPRESS_GET_CONFIG 0x02
+
+/* Used for throttle control */
+#define THROTTLED 0x1
+#define ACTUALLY_THROTTLED 0x2
+
+/* chiptypes - used in case firmware differs from the generic form ... offering
+ * 	different baud speeds/etc.
+ */
+
+#define CT_EARTHMATE	0x01
+#define CT_CYPHIDCOM	0x02
+#define CT_GENERIC	0x0F
+/* End of chiptype definitions */
+
+/* RS-232 serial data communication protocol definitions */
+/* these are sent / read at byte 0 of the input/output hid reports */
+/* You can find these values defined in the CY4601 USB to Serial design notes */
+
+#define CONTROL_DTR 	0x20	/* data terminal ready - flow control - host to device */
+#define UART_DSR	0x20	/* data set ready - flow control - device to host */
+#define CONTROL_RTS 	0x10	/* request to send - flow control - host to device */
+#define UART_CTS	0x10	/* clear to send - flow control - device to host */
+#define	UART_RI		0x10	/* ring indicator - modem - device to host */ 
+#define UART_CD		0x40	/* carrier detect - modem - device to host */
+#define CYP_ERROR 	0x08	/* received from input report - device to host */
+/* Note - the below has nothing to to with the "feature report" reset */
+#define CONTROL_RESET	0x08  	/* sent with output report - host to device */
+
+/* End of RS-232 protocol definitions */
+
+#endif /* CYPRESS_M8_H */