Merge tag 'armsoc-drivers' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc

Pull ARM SoC driver updates from Olof Johansson:
 "Various driver updates for platforms:

   - A larger set of work on Tegra 2/3 around memory controller and
     regulator features, some fuse cleanups, etc..

   - MMP platform drivers, in particular for USB PHY, and other smaller
     additions.

   - Samsung Exynos 5422 driver for DMC (dynamic memory configuration),
     and ASV (adaptive voltage), allowing the platform to run at more
     optimal operating points.

   - Misc refactorings and support for RZ/G2N and R8A774B1 from Renesas

   - Clock/reset control driver for TI/OMAP

   - Meson-A1 reset controller support

   - Qualcomm sdm845 and sda845 SoC IDs for socinfo"

* tag 'armsoc-drivers' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc: (150 commits)
  firmware: arm_scmi: Fix doorbell ring logic for !CONFIG_64BIT
  soc: fsl: add RCPM driver
  dt-bindings: fsl: rcpm: Add 'little-endian' and update Chassis definition
  memory: tegra: Consolidate registers definition into common header
  memory: tegra: Ensure timing control debug features are disabled
  memory: tegra: Introduce Tegra30 EMC driver
  memory: tegra: Do not handle error from wait_for_completion_timeout()
  memory: tegra: Increase handshake timeout on Tegra20
  memory: tegra: Print a brief info message about EMC timings
  memory: tegra: Pre-configure debug register on Tegra20
  memory: tegra: Include io.h instead of iopoll.h
  memory: tegra: Adapt for Tegra20 clock driver changes
  memory: tegra: Don't set EMC rate to maximum on probe for Tegra20
  memory: tegra: Add gr2d and gr3d to DRM IOMMU group
  memory: tegra: Set DMA mask based on supported address bits
  soc: at91: Add Atmel SFR SN (Serial Number) support
  memory: atmel-ebi: switch to SPDX license identifiers
  memory: atmel-ebi: move NUM_CS definition inside EBI driver
  soc: mediatek: Refactor bus protection control
  soc: mediatek: Refactor sram control
  ...

1 files changed, 0 insertions, 100 deletions

diff --git a/drivers/soc/qcom/llcc-sdm845.c b/drivers/soc/qcom/llcc-sdm845.c
deleted file mode 100644
index 86600d97c36d..000000000000
--- a/drivers/soc/qcom/llcc-sdm845.c
+++ /dev/null
@@ -1,100 +0,0 @@
-// SPDX-License-Identifier: GPL-2.0
-/*
- * Copyright (c) 2017-2018, The Linux Foundation. All rights reserved.
- *
- */
-
-#include <linux/kernel.h>
-#include <linux/module.h>
-#include <linux/of.h>
-#include <linux/of_device.h>
-#include <linux/soc/qcom/llcc-qcom.h>
-
-/*
- * SCT(System Cache Table) entry contains of the following members:
- * usecase_id: Unique id for the client's use case
- * slice_id: llcc slice id for each client
- * max_cap: The maximum capacity of the cache slice provided in KB
- * priority: Priority of the client used to select victim line for replacement
- * fixed_size: Boolean indicating if the slice has a fixed capacity
- * bonus_ways: Bonus ways are additional ways to be used for any slice,
- *		if client ends up using more than reserved cache ways. Bonus
- *		ways are allocated only if they are not reserved for some
- *		other client.
- * res_ways: Reserved ways for the cache slice, the reserved ways cannot
- *		be used by any other client than the one its assigned to.
- * cache_mode: Each slice operates as a cache, this controls the mode of the
- *             slice: normal or TCM(Tightly Coupled Memory)
- * probe_target_ways: Determines what ways to probe for access hit. When
- *                    configured to 1 only bonus and reserved ways are probed.
- *                    When configured to 0 all ways in llcc are probed.
- * dis_cap_alloc: Disable capacity based allocation for a client
- * retain_on_pc: If this bit is set and client has maintained active vote
- *               then the ways assigned to this client are not flushed on power
- *               collapse.
- * activate_on_init: Activate the slice immediately after the SCT is programmed
- */
-#define SCT_ENTRY(uid, sid, mc, p, fs, bway, rway, cmod, ptw, dca, rp, a) \
-	{					\
-		.usecase_id = uid,		\
-		.slice_id = sid,		\
-		.max_cap = mc,			\
-		.priority = p,			\
-		.fixed_size = fs,		\
-		.bonus_ways = bway,		\
-		.res_ways = rway,		\
-		.cache_mode = cmod,		\
-		.probe_target_ways = ptw,	\
-		.dis_cap_alloc = dca,		\
-		.retain_on_pc = rp,		\
-		.activate_on_init = a,		\
-	}
-
-static struct llcc_slice_config sdm845_data[] =  {
-	SCT_ENTRY(LLCC_CPUSS,    1,  2816, 1, 0, 0xffc, 0x2,   0, 0, 1, 1, 1),
-	SCT_ENTRY(LLCC_VIDSC0,   2,  512,  2, 1, 0x0,   0x0f0, 0, 0, 1, 1, 0),
-	SCT_ENTRY(LLCC_VIDSC1,   3,  512,  2, 1, 0x0,   0x0f0, 0, 0, 1, 1, 0),
-	SCT_ENTRY(LLCC_ROTATOR,  4,  563,  2, 1, 0x0,   0x00e, 2, 0, 1, 1, 0),
-	SCT_ENTRY(LLCC_VOICE,    5,  2816, 1, 0, 0xffc, 0x2,   0, 0, 1, 1, 0),
-	SCT_ENTRY(LLCC_AUDIO,    6,  2816, 1, 0, 0xffc, 0x2,   0, 0, 1, 1, 0),
-	SCT_ENTRY(LLCC_MDMHPGRW, 7,  1024, 2, 0, 0xfc,  0xf00, 0, 0, 1, 1, 0),
-	SCT_ENTRY(LLCC_MDM,      8,  2816, 1, 0, 0xffc, 0x2,   0, 0, 1, 1, 0),
-	SCT_ENTRY(LLCC_CMPT,     10, 2816, 1, 0, 0xffc, 0x2,   0, 0, 1, 1, 0),
-	SCT_ENTRY(LLCC_GPUHTW,   11, 512,  1, 1, 0xc,   0x0,   0, 0, 1, 1, 0),
-	SCT_ENTRY(LLCC_GPU,      12, 2304, 1, 0, 0xff0, 0x2,   0, 0, 1, 1, 0),
-	SCT_ENTRY(LLCC_MMUHWT,   13, 256,  2, 0, 0x0,   0x1,   0, 0, 1, 0, 1),
-	SCT_ENTRY(LLCC_CMPTDMA,  15, 2816, 1, 0, 0xffc, 0x2,   0, 0, 1, 1, 0),
-	SCT_ENTRY(LLCC_DISP,     16, 2816, 1, 0, 0xffc, 0x2,   0, 0, 1, 1, 0),
-	SCT_ENTRY(LLCC_VIDFW,    17, 2816, 1, 0, 0xffc, 0x2,   0, 0, 1, 1, 0),
-	SCT_ENTRY(LLCC_MDMHPFX,  20, 1024, 2, 1, 0x0,   0xf00, 0, 0, 1, 1, 0),
-	SCT_ENTRY(LLCC_MDMPNG,   21, 1024, 0, 1, 0x1e,  0x0,   0, 0, 1, 1, 0),
-	SCT_ENTRY(LLCC_AUDHW,    22, 1024, 1, 1, 0xffc, 0x2,   0, 0, 1, 1, 0),
-};
-
-static int sdm845_qcom_llcc_remove(struct platform_device *pdev)
-{
-	return qcom_llcc_remove(pdev);
-}
-
-static int sdm845_qcom_llcc_probe(struct platform_device *pdev)
-{
-	return qcom_llcc_probe(pdev, sdm845_data, ARRAY_SIZE(sdm845_data));
-}
-
-static const struct of_device_id sdm845_qcom_llcc_of_match[] = {
-	{ .compatible = "qcom,sdm845-llcc", },
-	{ }
-};
-
-static struct platform_driver sdm845_qcom_llcc_driver = {
-	.driver = {
-		.name = "sdm845-llcc",
-		.of_match_table = sdm845_qcom_llcc_of_match,
-	},
-	.probe = sdm845_qcom_llcc_probe,
-	.remove = sdm845_qcom_llcc_remove,
-};
-module_platform_driver(sdm845_qcom_llcc_driver);
-
-MODULE_DESCRIPTION("QCOM sdm845 LLCC driver");
-MODULE_LICENSE("GPL v2");