diff options
author | Krzysztof Wojcik <krzysztof.wojcik@intel.com> | 2011-02-04 14:18:26 +0100 |
---|---|---|
committer | NeilBrown <neilb@suse.de> | 2011-02-08 11:49:02 +1100 |
commit | 02214dc5461c36da26a34014cab4e1bb484edba2 (patch) | |
tree | 32137bdf12144af5ff6c946838e1bfbf3b2bc0f2 /drivers/md | |
parent | e91ece5590b3c728624ab57043fc7a05069c604a (diff) |
FIX: md: process hangs at wait_barrier after 0->10 takeover
Following symptoms were observed:
1. After raid0->raid10 takeover operation we have array with 2
missing disks.
When we add disk for rebuild, recovery process starts as expected
but it does not finish- it stops at about 90%, md126_resync process
hangs in "D" state.
2. Similar behavior is when we have mounted raid0 array and we
execute takeover to raid10. After this when we try to unmount array-
it causes process umount hangs in "D"
In scenarios above processes hang at the same function- wait_barrier
in raid10.c.
Process waits in macro "wait_event_lock_irq" until the
"!conf->barrier" condition will be true.
In scenarios above it never happens.
Reason was that at the end of level_store, after calling pers->run,
we call mddev_resume. This calls pers->quiesce(mddev, 0) with
RAID10, that calls lower_barrier.
However raise_barrier hadn't been called on that 'conf' yet,
so conf->barrier becomes negative, which is bad.
This patch introduces setting conf->barrier=1 after takeover
operation. It prevents to become barrier negative after call
lower_barrier().
Signed-off-by: Krzysztof Wojcik <krzysztof.wojcik@intel.com>
Signed-off-by: NeilBrown <neilb@suse.de>
Diffstat (limited to 'drivers/md')
-rw-r--r-- | drivers/md/raid10.c | 6 |
1 files changed, 4 insertions, 2 deletions
diff --git a/drivers/md/raid10.c b/drivers/md/raid10.c index 69b659544390..3b607b28741b 100644 --- a/drivers/md/raid10.c +++ b/drivers/md/raid10.c @@ -2463,11 +2463,13 @@ static void *raid10_takeover_raid0(mddev_t *mddev) mddev->recovery_cp = MaxSector; conf = setup_conf(mddev); - if (!IS_ERR(conf)) + if (!IS_ERR(conf)) { list_for_each_entry(rdev, &mddev->disks, same_set) if (rdev->raid_disk >= 0) rdev->new_raid_disk = rdev->raid_disk * 2; - + conf->barrier = 1; + } + return conf; } |