Merge tag 'boards' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc

Board-level changes

This adds and extends support for specific boards on a number of
ARM platforms:  omap, imx, samsung, tegra, ...

* tag 'boards' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc: (49 commits)
  Enable 32 bit flash support for iMX21ADS board
  ARM: mx31pdk: Add MC13783 RTC support
  iomux-mx25: configuration to support CSPI3 on CSI pins
  MX1:apf9328: Add i2c support
  mioa701: add newly available DoC G3 chip
  arm/tegra: remove __initdata annotation from pinmux tables
  arm/tegra: Use bus notifiers to trigger pinmux setup
  arm/tegra: Refactor board-*-pinmux.c to share code
  arm/tegra: Fix mistake in Trimslice's pinmux
  arm/tegra: Rework Seaboard-vs-Ventana pinmux table
  arm/tegra: Remove useless entries from ventana_pinmux[]
  arm/tegra: PCIe: Remove include of mach/pinmux.h
  arm/tegra: Harmony PCIe: Don't touch pinmux
  arm/tegra: Add AUXDATA for tegra-pinmux and tegra-gpio
  arm/tegra: Split Seaboard GPIO table to allow for Ventana
  ARM: imx6q: generate imx6q dtb files
  arm/imx6q: Rename Sabreauto to Armadillo2
  arm/imx6q-sabrelite: add enet phy ksz9021rn fixup
  arm/imx6: add imx6q sabrelite board support
  dts/imx: rename uart labels to consistent with hw spec
  ...

2 files changed, 35 insertions, 0 deletions

diff --git a/arch/arm/plat-omap/include/plat/uncompress.h b/arch/arm/plat-omap/include/plat/uncompress.h
index 7fbc361946b5..6ee90495ca4c 100644
--- a/arch/arm/plat-omap/include/plat/uncompress.h
+++ b/arch/arm/plat-omap/include/plat/uncompress.h
@@ -179,6 +179,9 @@ static inline void __arch_decomp_setup(unsigned long arch_id)
 		/* TI8168 base boards using UART3 */
 		DEBUG_LL_TI81XX(3, ti8168evm);
 
+		/* TI8148 base boards using UART1 */
+		DEBUG_LL_TI81XX(1, ti8148evm);
+
 	} while (0);
 }
 
diff --git a/arch/arm/plat-omap/include/plat/usb.h b/arch/arm/plat-omap/include/plat/usb.h
index 17d3c939775c..c616385f27bd 100644
--- a/arch/arm/plat-omap/include/plat/usb.h
+++ b/arch/arm/plat-omap/include/plat/usb.h
@@ -114,6 +114,7 @@ extern void am35x_musb_reset(void);
 extern void am35x_musb_phy_power(u8 on);
 extern void am35x_musb_clear_irq(void);
 extern void am35x_set_mode(u8 musb_mode);
+extern void ti81xx_musb_phy_power(u8 on);
 
 /*
  * FIXME correct answer depends on hmc_mode,
@@ -273,6 +274,37 @@ static inline void omap2_usbfs_init(struct omap_usb_config *pdata)
 #define CONF2_OTGPWRDN		(1 << 2)
 #define CONF2_DATPOL		(1 << 1)
 
+/* TI81XX specific definitions */
+#define USBCTRL0	0x620
+#define USBSTAT0	0x624
+
+/* TI816X PHY controls bits */
+#define TI816X_USBPHY0_NORMAL_MODE	(1 << 0)
+#define TI816X_USBPHY_REFCLK_OSC	(1 << 8)
+
+/* TI814X PHY controls bits */
+#define USBPHY_CM_PWRDN		(1 << 0)
+#define USBPHY_OTG_PWRDN	(1 << 1)
+#define USBPHY_CHGDET_DIS	(1 << 2)
+#define USBPHY_CHGDET_RSTRT	(1 << 3)
+#define USBPHY_SRCONDM		(1 << 4)
+#define USBPHY_SINKONDP		(1 << 5)
+#define USBPHY_CHGISINK_EN	(1 << 6)
+#define USBPHY_CHGVSRC_EN	(1 << 7)
+#define USBPHY_DMPULLUP		(1 << 8)
+#define USBPHY_DPPULLUP		(1 << 9)
+#define USBPHY_CDET_EXTCTL	(1 << 10)
+#define USBPHY_GPIO_MODE	(1 << 12)
+#define USBPHY_DPOPBUFCTL	(1 << 13)
+#define USBPHY_DMOPBUFCTL	(1 << 14)
+#define USBPHY_DPINPUT		(1 << 15)
+#define USBPHY_DMINPUT		(1 << 16)
+#define USBPHY_DPGPIO_PD	(1 << 17)
+#define USBPHY_DMGPIO_PD	(1 << 18)
+#define USBPHY_OTGVDET_EN	(1 << 19)
+#define USBPHY_OTGSESSEND_EN	(1 << 20)
+#define USBPHY_DATA_POLARITY	(1 << 23)
+
 #if defined(CONFIG_ARCH_OMAP1) && defined(CONFIG_USB)
 u32 omap1_usb0_init(unsigned nwires, unsigned is_device);
 u32 omap1_usb1_init(unsigned nwires);