i2c: designware: Do not complete i2c read without RX_FULL interrupt

Intel Keem Bay platform supports multi-master operations over same i2c
bus using Synopsys i2c DesignWare IP. When multi-masters initiate i2c
operation simultaneously in a loop, SCL line is stucked low forever
after few i2c operations. Following interrupt sequences are observed
in:
  working case: TX_EMPTY, RX_FULL and STOP_DET
  non working case: TX_EMPTY, STOP_DET, RX_FULL.

DW_apb_i2c stretches the SCL line when the TX FIFO is empty or when
RX FIFO is full. The DW_apb_i2c master will continue to hold the SCL
line LOW until RX FIFO is read.

Linux kernel i2c DesignWare driver does not handle above non working
sequence. TX_EMPTY, RX_FULL and STOP_DET routine execution are required
in sequence although RX_FULL interrupt is raised after STOP_DET by
hardware. Clear STOP_DET for the following conditions:
  (STOP_DET ,RX_FULL, rx_outstanding)
    Write Operation: (1, 0, 0)
    Read Operation:
      RX_FULL followed by STOP_DET: (0, 1, 1) -> (1, 0, 0)
      STOP_DET followed by RX_FULL: (1, 0, 1) -> (1, 1, 0)
      RX_FULL and STOP_DET together: (1, 1, 1)

Signed-off-by: Tamal Saha <tamal.saha@intel.com>
Signed-off-by: Jarkko Nikula <jarkko.nikula@linux.intel.com>
Signed-off-by: Wolfram Sang <wsa@kernel.org>

0 files changed, 0 insertions, 0 deletions